How to Make Released Transport back to Modifiable

SCENARIO:

We did some changes and collected it in transport. Now this is released for transport.

We found that there is something else left or change to be done we ideally end up collecting it in other transport request.

What is the issue?

Your change may not be reflected properly if the sequence of the transports diff when moving to target system.

Your project may be constraint in terms of approval and number of request to be sent Test, Prod.

This below program can be run before the released transport is initiated for target and if we intend to save further changes again in the same transport.

Though not that much important sometimes this program comes handy :-)

Program:

RDDIT076

   

Execute

After Execution:

Double click on every request/task and go to change mode

Now Change Status from R to D and request will go back to Modifiable State.